Everything below concerns melanocortin signalling. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Last reviewed on 2025-09-27. Where a claim depends on a specific study, the study is described rather than over-claimed.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Semax is a synthetic seven-amino-acid peptide whose sequence extends the ACTH(4-10) fragment with a C-terminal proline-glycine-proline tripeptide. The commonly cited sequence is Met-Glu-His-Phe-Pro-Gly-Pro, giving a molecular formula near C37H51N9O10S and a molecular weight close to 813.9 g/mol. It belongs to the broader class of synthetic ACTH fragments studied for central nervous system effects rather than for adrenal steroid stimulation. In practice the material appears as a lyophilized white powder for laboratory work or as a dilute saline solution in clinical settings.
Development is attributed to researchers at the Institute of Molecular Genetics in Moscow during the early 1980s, building on earlier Soviet work with ACTH fragments. Russian regulatory approval followed for intranasal use, and the compound has remained commercially available there for decades. Most published human data originate from Russian and, later, some Eastern European clinical reports, which are not always accessible in English translation. Outside that region the material is generally handled as a research chemical rather than a licensed medicine.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
溶液状态的稳定性明显低于冻干粉。肽类在水溶液中可能经历水解、氧化与聚集，其中甲硫氨酸和天冬酰胺等残基常是敏感位点。Semax 含有甲硫氨酸，因此氧化风险相对突出。工作液一般主张现配现用，或冷藏并在数日内用尽。缓冲液种类、pH 和离子强度都会影响降解速率，而关于最佳条件的公开数据并不统一。
常规纯度与身份确认依赖反相高效液相色谱，并辅以质谱测定分子量。氨基酸组成分析可用于验证序列构成，肽图分析则能进一步定位修饰或降解产物。杂质谱通常关注缺失序列肽、截短片段和氧化产物。不同方法的检出限并不相同，因此各实验室报告的纯度数值不宜直接横向比较。
多数实验室与市售的 Semax 以冻干粉形式提供。冻干粉通常建议保存在 -20 °C 或更低温度下，同时避免光照与反复升温。短期运输有时采用冷藏条件，但长期保存仍以冷冻为主。分包操作应尽量减少开盖次数，以降低吸湿和微生物污染的风险。开封后若未一次用完，建议在干燥环境中密封并尽快放回低温储存。
Pharmacological accounts link semax to melanocortin signalling and to modulation of neurotrophic factor expression, particularly brain-derived neurotrophic factor and nerve growth factor. Much of this evidence comes from rodent studies using intranasal delivery, a route chosen because it allows peptides to reach the central nervous system with limited systemic exposure. Whether the same mechanisms operate in humans at comparable magnitude remains an open question. The precise receptor or receptors responsible for the reported behavioural and neuroprotective effects have not been conclusively identified.
Clinical reports describe use in ischaemic stroke, transient ischaemic attack, optic nerve conditions, and cognitive complaints, but most of these studies are small and were conducted in a single region. Systematic reviews have generally described the evidence base as limited in size and variable in methodological quality. Randomised controlled data suitable for international regulatory assessment are scarce. As a result, major treatment guidelines outside Russia do not include the peptide, and interest in it remains largely research-driven rather than routine clinical.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It is described in the literature as an analogue of the ACTH(4–10) fragment, a short N-terminal portion of adrenocorticotropic hormone that retains some neurotropic activity without the full hormonal effects of the parent peptide. The molecule carries a methionine residue at the N-terminus and two proline residues near the C-terminus, features that shape both its interactions with receptor systems and its chemical stability. The free peptide corresponds to the formula C37H51N9O10S and a molecular mass near 813.9 Da.
Routine characterization relies on reversed-phase high-performance liquid chromatography to establish purity and on mass spectrometry to confirm molecular identity. Electrospray ionization and matrix-assisted laser desorption ionization are both used for mass verification. Amino acid analysis and peptide mapping can detect sequence errors. Common impurities include truncated sequences, methionine sulfoxide formed by oxidation, and deamidated products. Chromatograms are usually recorded near 214 nm, where the peptide backbone absorbs, and purity is reported as the percentage area of the principal peak.
Verification of a supplied batch generally combines a certificate of analysis with independent testing, because certificates are self-reported documents. A typical package includes a chromatographic trace, a mass spectrum, and a stated water or counter-ion content. Batch-to-batch consistency matters more than a single purity figure when results are compared across experiments. No single mandatory standard governs research-grade peptide release, so laboratories are expected to define their own acceptance criteria. Residual trifluoroacetate from purification is a frequently overlooked counter-ion.
Semax is a synthetic heptapeptide with the sequence Met-Glu-His-Phe-Pro-Gly-Pro. It corresponds to the ACTH(4-7) fragment extended at the C-terminus by a Pro-Gly-Pro tripeptide, an addition intended to slow enzymatic breakdown. The molecular formula is C37H51N9O10S and the molecular mass is approximately 814 daltons. In the literature it is often described as an ACTH(4-10) analog, although that label reflects a naming convention as much as a precise structural relationship. The compound was developed in Russia and remains most closely associated with that research tradition.
Laboratory descriptions of the material are consistent across suppliers. It appears as a white to off-white lyophilized powder that dissolves readily in water and in polar organic solvents such as dimethyl sulfoxide. Aqueous solutions are clear and colorless at low concentrations. Because the peptide contains methionine, oxidation at the sulfur atom is a recognized degradation pathway, and handling notes usually call for protected, desiccated storage. Reported purity for research-grade lots is generally above 95 percent as measured by reversed-phase high-performance liquid chromatography.
=== Matrix === The matrix system has a drug layer of a semisolid matrix containing a drug solution or suspension. The adhesive layer in this patch surrounds the drug layer, partially overlaying it. The release rate is determined by the physical properties of the matrix. Also known as a monolithic device. Limited research indicates that it may be possible to cut some matrix patches to provide lower doses, provided the cut part not immediately used is stored at cool temperatures.
== Detection technique == Helium is used as a tracer because it penetrates small leaks rapidly. Helium also has the properties of being non-toxic, chemically inert and present in the atmosphere only in minute quantities (<6 ppm). Typically a helium leak detector will be used to measure leaks in the range of 10−5 to 10−12 Pa·m3·s−1. When a mass spectrometer is used to sample the leaking helium leaks can be detected up to 10−14 Pa·m3·s−1. A flow of 10−5 Pa·m3·s−1 is about 0.006 ml per minute at standard conditions for temperature and pressure (STP). A flow of 10−13 Pa·m3·s−1 is about 0.003 ml per century at STP.
== Mechanics, engineering, and implements == Bar-link chain (or block chain), a mechanical drive chain Bicycle chain, a roller chain that transfers power from the pedals to the drive-wheel of a bicycle Buffers and chain coupler, a railway device Catenary (or chain), the shape of a hanging flexible cable when supported at its ends and acted upon by a uniform gravitational force Chain Home and Chain Home Low, early British RDF (radar) systems of the WWII era Chain tool, a small mechanical device used to "break" a bicycle chain in such a way that it could be mended with the same tool Conveyor chain, a chain that conveys items in chain conveyor systems Drive chain, a way of transmitting mechanical power from one place to another Print chain on a chain printer Roller chain, most commonly used for transmission of mechanical power Self-lubricating chain, to eliminate the need for further lubrication Snow chains or tire chains, devices fitted to the tires of vehicles to provide maximum traction Timing chain, part of an internal combustion engine
Sources: en.wikipedia.org
Moreover, the amyloid β-protein deposit and nerve cell apoptosis were retarded. An observed inhibitory impact of oxytocin on the inflammatory activity of the microglia was proposed to be an important factor.
=== Women's health === Sexual intercourse between women and circumcised, as compared to uncircumcised, men is associated with a decreased risk of cervical cancer, cervical dysplasia, HSV-2, chlamydia, and syphilis among women. The evidence is less consistent in regard to an association of circumcision with women's risk of HPV and HIV.
=== Preservation === Examples of many styles of refrigerators and ice cars can be found at railroad museums around the world. The Western Pacific Railroad Museum at Portola, California features a very complete roster of 20th-century cars, including wood-bodied ice cars, steel-bodied ice cars, one of the earliest mechanical refrigerator cars, later mechanical refrigerator cars, and a cryogenic reefer, as well as several "insulated" boxcars also used for food transport.
=== Food processing levels === The level of measurement in food processing classification uses nominal or ordinal variables for qualitative grouping of food processing. Processed food classifications, such as the Nova classification, categorise processed foods and often use subjective criteria in processed foods grouping. Nominal food processing classifications group food processing according to qualitative variables, such as raw material sources, purpose of processing, traditional or novel, and type of treatment. Food processing levels (FPL) are derived from ordinal scaling of food processing impact on processed foods. Food processing levels (Table 1) indicate the object and result of food processing and provide means for the use of the extent of food processing at an ordinal scale for various purposes, e.g., processed food classification. The relative impact of FPL on the expected extent of food processing results from the combined effects of physical and chemical changes during food processing as is described in Figure 1.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
It is a short synthetic peptide built from seven amino acids: methionine, glutamic acid, histidine, phenylalanine and three prolines. The sequence derives from the 4-10 fragment of adrenocorticotropic hormone with an added proline-glycine-proline tail. No plant or animal extract is involved; the material is produced by solid-phase peptide synthesis.